@nicgeosciences:

did you load the grid file using the “Load Input Graph” menu, specifying the demFileName, demVerticalScale and demVerticalShift parameters in the input graph file?
If so, then try and play with the demVerticalScale value. This worked for me.

Hi Lithop.
I’ve had difficulties uploading my replies…

Fetch DEM files of any part of the Earth, at a 30 meter resolution, from this URL (possibly needs an account creation, but it’s all free).

I found the answer to my questions above (see the extract below from Matt Wilkie):

To load a DEM.grid file into the AR Sandbox, press any key while it’s running, and select “Show DEM” from the tool selection menu. In the file selection box that appears, select a DEM file. If the file could be read correctly, pressing the same key afterwards will toggle the AR Sandbox into DEM mode, where blue indicates an excess of sand, and red indicates a lack of sand. Move sand from the blue to the red areas until everything is white (ideally). Pressing the bound key again will toggle back to regular mode.

The DEM mapping tool can be configured to adjust the DEM’s vertical level (to make the DEM match the total amount of sand in the box), its vertical exaggeration, and the tolerance level when the sand is colored white. To adjust these settings, it is easiest to assign a DEM tool as above, and then save the current tool setup by selecting “Save Input Graph” from the “Devices” sub-menu of the Vrui system menu. This creates a text file with the settings for the DEM tool inside. After adjusting the settings, the complete tool setup can be loaded back from inside the AR Sandbox by selecting “Load Input Graph,” or at startup by passing -loadInputGraph on SARndbox’s command line.

If everything is blue, the loaded DEM is below the current sand surface everywhere (blue means too much sand, red means too little sand).

To adjust the DEM vertically, run the sandbox and load your DEM by assigning a “Show DEM” tool to some button. Once it’s assigned, select “Save Input Graph…” from the “Devices” sub-menu of Vrui’s system menu. Then exit the sandbox and open the file to which you saved.

It’s the same format as other Vrui configuration files, with one section per assigned tool. Find the section that says “toolClass DEMTool”. Into that section, put a new line demVerticalShift 0.0 then save the file, run the sandbox again, and load the saved input graph from the “Devices” sub-menu.

You can also put the DEM file name in that section via demFileName so you don’t have to select it every time.

The trick is to fiddle with the vertical shift value by editing the input graph file until you have just enough sand to recreate the entire DEM. You can edit the file while the sandbox is running, and re-load the changes by selecting “Load Input Graph…” again.

If you have blue everywhere, use a large negative shift until everything is red. Then bisect until you get it just right.

It will look something like this:

section DEMTool2
toolClass DEMTool
bindings ((Mouse, 4))
demFileName /home/okreylos/Projects/Sandbox/LakeTahoe.grid
demVerticalScale 4.0
demVerticalShift -1.5 # Positive values make it blue-er, negative values red-er
endsection

• This reply was modified 2 years ago by Playnetary.