jdbaker500

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Broken link to updated calibration? #2813
    jdbaker500
    Participant

    Thanks for the reply, robbo. It wasn’t so much impatience as it was noticing questions asked after were answered, so I took that as my question didn’t need answering.

    The link you site was the page I originally found for the project, which links to the “these basic instructions” page, which links to the “obsolete” videos of steps 4 and 5. Maybe it’s straightforward to figure out what is still valid in those videos.

    in reply to: Broken link to updated calibration? #2810
    jdbaker500
    Participant

    As there is no response I take it that we should ignore the warning that those videos for steps 4 and 5 are obsolete and go ahead and use them for calibration. I’m posting this so future developers will understand this.

Viewing 2 posts - 1 through 2 (of 2 total)