Did you have any luck with this?

When I run the SARndbox executable directly, it runs (no color elevation ramps from .cpt file of course),

however when I run the .sh file with the arguments the screen is black.

/opt/SARndbox-3.2/bin/RunSARndbox.sh

Thanks for updating the Kinect installer.
Having similar problems with not being able to write after updating still.

I get a new permission to write error when running Calibration of Kinect sensor.

I determined two of my sensors are ready for the recycling pile and three are not.

I still get hung up on this error while rebuilding the sandbox under Linux Mint Mate Wilma:

[my installation]$ KinectUtil getCalib
Downloading factory calibration data for Kinect A00362A00580128A…
Depth conversion formula: dist[mm] = 345489 / (1089.41 – depth)

Depth unprojection matrix:
0.00173667 0.00000000 0.00000000 -0.55573332
0.00000000 0.00173667 0.00000000 -0.41679999
0.00000000 0.00000000 0.00000000 -1.00000000
0.00000000 0.00000000 -0.00000289 0.00315323
Depth-to-color pixel shift formula: Shift = 11.4115 – 13243.8/dist[mm]
Or: Shift = -30.3492 + 0.0383333*depth
Calculating best-fit color projection matrix for depth value range 399 – 975…
Smallest eigenvalue of color system = 0.00740349
Optimal homography from depth space to color image space:
0.91976413 -0.00270476 0.05811749 -0.02265099
0.00001878 0.91417774 -0.00013181 0.00629913
0.00000000 0.00000000 1.00000000 0.00000000
0.00218374 -0.00689068 -0.00028243 1.00000000
Color matrix approximation RMS = 0.0679395
Writing full intrinsic camera parameters to /opt/Vrui-12.2/etc/Kinect-4.2/IntrinsicParameters-A00362A00580128A.dat
terminate called after throwing an instance of ‘IO::File::OpenError’
what(): IO::StandardFile::openFile: Cannot open file /opt/Vrui-12.2/etc/Kinect-4.2/IntrinsicParameters-A00362A00580128A.dat for writing due to libc error 13 (Permission denied)
Aborted (core dumped)